Pinnacle hot baths comes in many different models, which range from small two seaters to large swim spas. Whichever type of tub which you have, it comes with a complete factory warranty and a support program. That does not mean you won’t occasionally encounter issues with your tub, though — and a few troubleshooting processes are simple to enough to perform yourself.
Failure to Operate
If your hot tub won’t turn on, check the power. The hot tub comes with a ground-fault circuit interrupter (GFCI) breaker box to help monitor the electricity throughout the circuit. If the breaker is tripped, the tub does not operate. Check the breaker and reset it if needed. If the hot tub still does not operate, turn off the electricity and inspect the breaker for loose wiring; contact an electrician if there is damage. If the breaker box is in working order and the tub still does not operate, check your home’s circuit breaker or fuse box. Reset the breaker or replace a blown fuse if needed.
Pressure Problems
When the hot tub has no or low jet pressure, there are numerous possible causes. Verify the jets to be certain they’re open; turn them counterclockwise to open them fully. Examine the bathtub’s filter for dirt or clogs which may stop the flames from properly functioning; clean or replace the filter as necessary. The jets may experience low pressure if the valves are closed. Make certain each of the T-handle shutoff valves on the heat pumps are open. Inspect the air control valves; these should be closed for suitable jet pressure. Ensure your bathtub’s water level is high enough. The tub should be filled to about 1 inch over all the jets.
Chilly Water
If the water isn’t heating Sacramento repair specialists, check the thermostat. Reset it to the desired temperature. If the thermostat is set correctly but the water does not heat, be certain that the air control valve is closed. Inspect the slide valve too; it needs to be open for proper Sacramento AC repair specialists. Additionally, the water might not heat whether the filter is dirty, so wash out the filter if needed. Your hot tub won’t heat correctly if it is at “Economy Mode,” that lowers the established temperature stage by 20 levels at a specific period of the afternoon. To take your hot tub out of the Economy Mode, press the “Standby” button on the controller panel.
Foamy Water
If your find the water is foamy or fragile, it’s probably the result of soap, sunscreen, body cream or cream from bathers’ seams or seams sanitizer particles. To wash out the water, close the air-control valves and run the filtration cycle. If the water is foamy then, you might need to clean and drain the hot tub so you can refill it with clean water. It also will help to clean or change the bathtub’s filters. To prevent future issues, have bathers rinse off before they enter the hot tub.